Connecting The Lan And Serial Port Cables - IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

2. Connect one end of the power cord 4 to the connector on the power supply
3. Connect the other end of the power cord 5 to a properly grounded electrical
4. Make sure that the Remote Supervisor Adapter power LED is green. For the
Continue with "Connecting the LAN and serial port cables".

Connecting the LAN and serial port cables

You can manage your server remotely using the connections and user interfaces
that are described in Table 9 on page 66. Choose the interface method you want to
use to perform remote management; then, perform the indicated cabling
procedure.
If you plan to set up an ASM interconnect network, go to "Planning and cabling
your interconnect network" on page 77 for instructions about cabling the ASM
interconnect port and setting up the network. Then, return here to continue the
cabling procedures.
Table 9. Cabling tasks to enable remote access to the Remote Supervisor Adapter
User interface to Remote
Supervisor Adapter
ASM Web interface using
the HTTP protocol
Text-based user interface
using the TELNET
protocol
66
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
1 .
adapter 3 .
outlet.
Note: Alternately, you can connect one end of the universal power cord to the
power supply adapter; then, connect the other end to a power
distribution unit (PDU) or to an uninterruptible power supply (UPS).
location of the power LED, see the illustration in "Cabling the Ethernet LAN
port" on page 67.
Connection to Remote
Supervisor Adapter
LAN using the Ethernet port
For the cabling procedure, see:
"Cabling the Ethernet LAN
port" on page 67