I/O Connector Locations And Ports In The R Pro; Input/Output Ports - IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

4. Install the screws and secure the cover as shown.
5. Reinstall the server/workstation in the rack (see "Rack installation" on
6. Reconnect the power cord and all external cables to the server/workstation,

I/O connector locations and ports in the R Pro

The following illustration shows the input/output connectors (ports) and the
expansion slots on the rear of the computer. For pin assignments and other details
about these connectors, see "Input/Output ports".
Ethernet 1

Input/Output ports

This section provides information about the input/output (I/O) ports on your
computer. These ports include the following:
v Console ports
v Serial port
v Universal Serial Bus (USB) ports
v Ethernet ports
v Advanced System Management (ASM) ports
v Audio ports
v Video ports
94
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
Attention: Before sliding the cover forward make sure that all of the tabs on
the cover will engage the ledge at the front of the server/workstation properly.
If all of the tabs do not engage the ledge properly, it will be extremely difficult
to remove the cover.
page 46).
then plug the power cords into electrical outlets.
RS-485 (Advanced
System Management
Interconnect) A
PCI slot 1 (video adapter)
Ethernet 2
USB 1
RS-485 (Advanced
System Management
Interconnect) B
PCI slot 2 (audio adapter)
USB 2 Console out
Serial port
Console in