Installing The Microprocessor - IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

Attention:
install microprocessors that are the same type, and have the same cache size and
the same clock speed. Microprocessor internal clock frequencies and external clock
frequencies must be identical. See the serverProven list at
http://www.ibm.com/pc/compat for a list of microprocessors for use with the
server/workstation.
Terminator card

Installing the microprocessor

Note: The illustrations may differ slightly from your hardware.
Complete the following steps to install an additional microprocessor:
Attention:
precautions to avoid damage from static electricity. For details on handling these
devices, refer to the following Web site and use a search term of ESD:
http://www.ibm.com/
1. Review the safety precautions listed in "Safety information" on page 147.
2. Turn off the server/workstation and peripheral devices and disconnect the
3. Remove the clear shield from the server/workstation and store it in a safe
4. Lift up the microprocessor release lever and remove the terminator card from
5. Install the microprocessor:
88
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
To avoid damage and ensure proper server/workstation operation
Slot
Top view of
heatsink
When you handle electrostatic discharge-sensitive devices (ESD), take
power cord and all external cables; then remove the cover (see "Removing the
cover" on page 48 for details).
place.
the microprocessor connector. (After you remove the new microprocessor from
the static-protective package, place the terminator card in the bag and store it
in a safe place. You will need to install the terminator card again if you ever
remove the microprocessor and do not replace the microprocessor.)
Heatsink release
lever
Clip
Heatsink
Microprocessor