6. Slide the power supply away from the side of the chassis and lift up to remove.
PCI riser card
To remove the PCI riser card:
Note: Read"Safety information" on page 147 and "Before you begin" on page 45.
1. Power off the server/workstation.
2. Remove the cover. See "Removing the cover" on page 48.
3. Remove any adapters and put them in a safe place.
4. Disconnect cables.
5. Gently lift up on the card to disconnect it from the system board port.
System board
To remove the system board:
Note: Read"Safety information" on page 147 and "Before you begin" on page 45.
1. Power off the server/workstation.
2. Remove the cover. See "Removing the cover" on page 48.
3. Disconnect all cables from the system board.
4. Remove the adapter retaining latch (see "Removing a microprocessor" on
5. Remove the microprocessors. See "Removing a microprocessor" on page 90.
6. Remove the memory modules. See "Installing memory modules" on page 85.
7. Remove screws from the system board.
8. Remove the four screws from the rear of the server/workstation.
9. Pull up on the system board to remove from the chassis.
116
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
page 90).