ScanSoft TEXTBRIDGE PROFESSIONAL EDITION 8.5 User Manual page 27

Basic scanner installation steps
I T
NSTALLING EXT
The basic steps for installing a scanner are to:
1. Hook up the scanner to the SCSI port or USB port (for USB
Macintoshes) with the correct cable, and power up the scanner
and the Macintosh. Refer to your scanner documentation for
complete instructions.
2. Install the scanner driver on your Macintosh hard disk, as
directed by the scanner documentation.
3. Test the scanner using software tools provided by the
manufacturer.
Make sure your scanner runs independently of TextBridge Pro.
After the scanner is functioning, install TextBridge Pro software.
B P S
RIDGE RO OFTWARE
After you have performed the scanner installation, and are sure
that it is functioning, you are ready to install TextBridge Pro
software. This section provides procedures to:
run the software installation program
select a scanner driver
If you are not using TextBridge Pro with a supported scanner,
Note
you can run the software installation program and ignore the
scanner selection instructions. For example, you might want to
use TextBridge Pro only to recognize image files produced by your
fax modem.
Installation
2–3