ScanSoft TEXTBRIDGE PROFESSIONAL EDITION 8.5 User Manual page 102

Indicates Instant Access
mode
To run TextBridge Pro from, and import recognized text directly
into, the host application's open document, use the following
procedure:
1. Start the host application, and open a document into
which you can import the recognized data.
Set the insertion point where you want TextBridge Pro to paste
text in the document.
2. Pull down the Apple menu and select the Instant Access
OCR command.
In a few moments, the TextBridge Pro main window appears in
Instant Access mode (Figure 4–9).
Figure 4–9. Main window in Instant Access mode
3. Set up and initiate OCR from the main window exactly as
if you were using the TextBridge Pro main application.
Refer to any of the step-by-step procedures in this chapter for
more information.
When OCR is complete, recognized text is pasted at the insertion
point in your application's open document. TextBridge Pro leaves
Instant Access mode, and waits for further instructions.
To return to Instant Access mode, select the Instant Access OCR
command from the Apple menu again.
Using TextBridge Pro
4–33