Turning Off Log Filters - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 2010-10-04 Reference Manual

JunosE 11.3.x System Event Logging Reference Guide
host1(config)# log severity debug bgpevents access-class ListOne route-map ?
WORD The route map
host1(config)# log severity debug bgpevents access-class ListOne route-map default ?
filtering-router Identify virtual router where access-class/route-map are defined
in Select import/in direction for the filter
out Select export/out direction for the filter
<cr>
host1(config)# log severity debug bgpevents access-class ListOne route-map default in

Turning Off Log Filters

no log filters
16
The next example limits the logging of PPP debug events to traffic to or from the POS
interface in slot 2/0.
host1(config)#log severity debug ppp ?
atm Specify an ATM PPP interface
fastEthernet Specify a fastEthernet interface
gigabitEthernet Specify a gigabitEthernet interface
mlppp Specify an MLPPP network interface
pos Specify a POS PPP interface
serial Specify a serial PPP interface
<cr>
host1(config)#log severity debug ppp pos 2/0
To obtain a list of the filters available in each event category, see "Event Categories" on
page 21 .
You can turn off filters in three ways:
Turn off all filters
Turn off all filters for an event category
Turn off a specific filter
To turn off all filters:
host1(config)#no log filters
To turn off all filters for an event category, use the no version of the log severity command
along with the category name. For example:
host1(config)#no log severity bgpEvents filters
To turn off a specific filter, use the no version of the log severity command that you used
to add the filter. For example:
host1(config)#no log severity bgpEvents peer 10.0.0.2 10.0.0.1
Use to turn off log filters.
To turn off all filters for an event category, specify the category name.
Example
host1(config)#no log filters
Copyright © 2010, Juniper Networks, Inc.