Bgpmessages - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 2010-10-04 Reference Manual

bgpMessages

Description
Emergency
Alert
Critical
Error
Warning Log
Notice Log
Info
Debug
Filter 1
Filter 2
Filter 3
Filter 4
Filter 5
Filter 6
Copyright © 2010, Juniper Networks, Inc.
BGP protocol messages
None
None
None
None
Unknown message type received; invalid field in received message; notification message
received or sent; invalid capability length in received ORF capability; invalid capability
value in received ORF capability; invalid ORF in received ORF capability; ORF entries
exceeded maximum limit in received prefix list
Open message received or sent; update message received or sent; route-refresh message
received or sent; route-refresh-cisco message received or sent; received ORF capability;
received route refresh message with ORF entries
None
Keepalive message received or sent (Full decode of message logged if verbosity is high)
NOTE: Send messages are logged to the bgpMessages log when a message
is added to the send queue. A debug message is logged to the bgpConnections
log when the message is actually passed to TCP.
access-class—This filter is not currently supported
peer—See description of the bgpRoutes peer filter for information about this filter
route-map—This filter is not currently supported
router—See description of the bgpRoutes router filter for information about this filter
in—Matches on traffic coming into the router
out—Matches on traffic going out of the router
Chapter 4: B Commands
41