Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 2010-10-04 Reference Manual page 37

Copyright © 2010, Juniper Networks, Inc.
Remove the assigned status of the atm event category and view the log configuration:
6.
host1(config)#no log severity atm
host1(config)#run show log config
log destination console severity WARNING
log destination nv-file severity CRITICAL
log destination syslog 10.10.4.240 facility 7 severity DEBUG
no log engineering
log fields timestamp instance no-calling-task
no log here
Warning: Logging to this terminal is disabled
log severity OFF
category
--------------------
aaaAtm1483Cfg
aaaEngineGeneral
aaaServerGeneral
aaaUserAccess
addressServerGeneral
ar1AaaServerGeneral
atm
atm1483
atmAal5
Notice that the atm event category follows the systemwide severity level of OFF. The
systemwide setting takes precedence over the atm event category default of Error.
Change all event categories, systemwide, to their default/unassigned levels, and view
7.
the log configuration:
host1(config)#no log severity *
Please wait....
host1(config)#run show log config
log destination console severity WARNING
log destination nv-file severity CRITICAL
log destination syslog 10.10.4.240 facility 7 severity DEBUG
no log engineering
log fields timestamp instance no-calling-task
no log here
Warning: Logging to this terminal is disabled
no log severity
category
--------------------
aaaAtm1483Cfg
aaaEngineGeneral
aaaServerGeneral
aaaUserAccess
addressServerGeneral
ar1AaaServerGeneral
atm
atm1483
atmAal5
Chapter 1: System Logging Overview
severity verbosity filters
-------- --------- -------
OFF low
OFF low
OFF low
OFF low
OFF low
OFF low
OFF low
OFF low
OFF low
severity verbosity filters
-------- --------- -------
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
notes
-----
1
1
1
1
1
1
1
1
1
notes
-----
13