Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 2010-10-04 Reference Manual page 221

pimIpv6HelloSentLog
Description
Emergency
Alert
Critical
Error
Warning Log
Notice Log
Info
Debug
Filter 1
Filter 2
pimIpv6PktsRcvdLog
Description
Emergency
Copyright © 2010, Juniper Networks, Inc.
ipv6-address—Specifies that you will identify the interface by entering an IPv6 address
ipv6Address —IPv6 address of interface for which you want to log events
unnumbered—Specifies that the interface is unnumbered
interfaceType—Type of interface for which you want to log events
interfaceSpecifier—Location of unnumbered interface in the appropriate format
NOTE: For information about interface types and specifiers, see Interface
Types and Specifiers in JunosE Command Reference Guide.
Protocol Independent Multicast (PIM) Hello messages sent
None
None
None
None
None
None
Short description of the PIM hello messages sent
Complete description of the PIM hello messages sent
interface-ipv6-address—See description of the pimIpv6HelloRcvdLog
interface-ipv6-address filter for information about this filter
router—See description of the pimIpv6HelloRcvdLog router filter for information about
this filter
Protocol Independent Multicast (PIM) nonhello
(Register/RegisterStop/JoinPrune/Assert/Graft/GraftAck) messages received
None
Chapter 15: P Commands
197