Declaration Of Conformity For Rf Exposure - Cisco Aironet 340 Series Installation And Configuration Manual

Appendix C Declarations of Conformity and Regulatory Information
The following CE mark is affixed to the 340 series equipment:
For the 350 series, the following standards were applied:
•
•
•
The following CE mark is affixed to the 350 series equipment:
The above CE mark is required as of April 8, 2000 but might change in the future.
Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted
to certain frequencies and/or may require a license for operation. For more details, contact your
customer service representative.
Note Combinations of power levels and antennas resulting in a radiated power level above 100 mW
equivalent isotropic radiated power (EIRP) are considered as not compliant with the above mentioned
directive and are not allowed for use within the European community and other countries that have
adopted the European R&TTE directive 1999/5/EC or the CEPT recommendation Rec 70.03 or both.
For more details on legal combinations of power levels and antennas, refer to the
Levels and Antenna Gains"

Declaration of Conformity for RF Exposure

The radio module has been evaluated under FCC Bulletin OET 65C and found compliant to the
requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) addressing RF Exposure
from radio frequency devices.
OL-1375-02
Radio: EN 300.328-1, EN 300.328-2
EMC: EN 301 489-1, EN 301 489-17
Safety: EN 60950
0650
section on page D-3.
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Declaration of Conformity for RF Exposure
"Maximum Power
C-5