CARLO GAVAZZI WM4-96 - PROGRAMMING Manual page 48

48
Outputs / Other settings
•Type: type of alarm: up alarm (MAX); down alarm (MIN); up
alarm with latch (UP L): in this case the reset of the output
can only be manual; down alarm with latch (D.L.): in this
case the reset of the output can only be manual; down
alarm with disabling at power ON (D.DO). Choose the
desired alarm type by means of the
confirm it with
•Set on: ON-alarm set-point. Select the value of the vari-
able by means of the
S
.
•Set off: OFF-alarm set-point. Select the value of the vari-
able by means of the
S
.
•Out: Normally energized alarm (NE) or normally de-ener-
gized alarm (ND). Choose the desired function by means of
the and
•Delay: delay on alarm activation. Select the desired delay
value in seconds by means of the
confirm it with
S
presence of the neutral connection. If the connection to the
neutral is not detected, the instrument activates an alarm.
Select "DIAGNOSTIC" by means of the
then press
back to the main menu, press
Counters reset
43
S
.
keys and confirm it with
S
.
S
to confirm it. To reset your choice and go
44
and keys and confirm it with
and keys and confirm it with
Diagnostic
In a 3-phase unbalanced-load
system, this function controls the
F
.
55
and keys and
S
.
and keys and
and
Modem
keys,
50