CARLO GAVAZZI WM4-96 - PROGRAMMING Manual page 46

46
The meaning of the symbols on the display is the following:
OUT C0 (1): digital output SLOT C0, channel 1
OUT C1 (2): digital output SLOT C1, channel 2
OUT D0 (3): digital output SLOT D0, channel 3
OUT D1 (4): digital output SLOT D1, channel 4
S
S
S
1.2..
S
..2.1
S
reactive energy (kvarh -), press the
menu of energy/pulse output management. There are five
possible selections: TOTAL, output connected to the total
energy meter; TARIFF, output connected to the desired tariff
Installed power
41
Outputs / Other settings
F
S
F
F
F
44
Pulse output
This function allows the user
to set the parameters of the
pulse output. The output can be
connected to a specific energy
and this energy can be connect-
ed to the desired tariff. The
measured energy is re-transmit-
ted by means of the pulse output
(the pulses/energy ratio of which
is programmable). Use
to select PULSE from the list
of available outputs; then con-
S
firm with
the submenu ENERGY TYPE the
energy to be retransmitted using
and
energy (kWh +), generated active
energy (kWh -), consumed reac-
tive energy (kvarh +), generated
S
55
and choose from
: consumed active
key to open the
Diagnostic
and
48