MACROMEDIA FLASH 8-USING FLASH Use Manual page 143

To add an anchor point:
Click a line segment with the Pen tool.
To delete an anchor point, do one of the following:
To delete a corner point, click the point once with the Pen tool.
To delete a curve point, click the point twice with the Pen tool. (Click once to convert the
point to a corner point, and once more to delete the point.)
Select the point with the Subselection tool and press Delete.
Adjusting segments
You can adjust straight segments to change the angle or length of the segment, or adjust
curved segments to change the slope or direction of the curve.
When you move a tangent handle on a curve point, the curves on both sides of the point
adjust. When you move a tangent handle on a corner point, only the curve on the same side
of the point as the tangent handle adjusts.
To adjust a straight segment:
1.
Select the Subselection tool, and select a straight segment.
2. Use the Subselection tool to drag an anchor point on the segment to a new position.
To adjust a curve segment:
Select the Subselection tool and drag the segment.
When you click the path, Flash shows the anchor points. Adjusting a segment with
the Subselection tool may add points to the path.
Using the Pen tool 143