Remote Control By Sms - Visonic POWERMAXPRO User Manual

The PowerMax Pro can be programmed by the
installer for selective transmission of messages to
private telephone subscribers. Messages are divided
by type into 4 groups:
Group Events Reported
1 Fire, Burglary, Panic, Tamper
2 Arming AWAY, Arming HOME, Disarming
3 No-activity, Emergency, Latchkey, Gas,
Flood, Temperature
4 Low-battery AC failure
When the called party answers a call initiated by the
PowerMax Pro, he will hear a verbal message
composed of the "house identity" and the type of event
that occurred. For example, once smoke is detected in
the Smith residence, the message will be:
[The Smith Residence - Fire Alarm].
If a person under surveillance in the Watkins
residence has been inactive, the message will be:
[The Watkins Residence - No Activity].
The called party must acknowledge the message (as
explained later on), but if he does not respond, the
message will be transmitted repeatedly as many
times as possible within a 45-second time limit.
When the 45 seconds are up, the PowerMax Pro will
disengage the line and call the next private
telephone number on its list.
The called party can acknowledge the message by
pressing a key on the telephone keypad, as follows.
Command
Acknowledge only: The PowerMax Pro
disengages the line and considers the
event duly reported.
Acknowledge and listen-in: The protected
site is "bugged" for sound for 50 seconds.
The called party may prolong the listening
session by pressing [3] again before the
PowerMax Pro disengages the line, or by
pressing [1] to speak.
D-302542
Command
Acknowledge and speak out: The called
party may speak for 50 seconds to
whoever is in the protected site. The called
party may prolong the "speak out" session
by pressing
PowerMax Pro disengages the line, or by
pressing [3] to listen.
Acknowledge and 2-way conversation: You
and the called party can speak and listen
without any necessity to switch the system
from "listen-in" to "speak-out" and vice versa
for 50 sec. (extendable).
Acknowledge and
report: The PowerMax Pro will issue a
verbal report of system status. For example:
[Disarm - ready to arm] or
[Disarm - back door open] or
[Disarm - alarm in memory].

Remote Control by SMS

PowerMax Pro system with GSM unit can respond to
SMS commands from any cellular telephone.
The various SMS commands are detailed in the
following table (the detailed SMS message sending
process is described in the cellular telephone user's
guide). In this table, "<code>" means 4-digit user
code and blank space simply means blank space.
Key
2
In the following table, "P#" is used only for
PowerMax Pro with partition enabled - use P1, P2,
P3, or P4, according to the partition number.
3
SPECIAL FUNCTIONS
[1] again before
request a
SMS Command List
Key
1
the
6
status 9
23