Tasksmart W2200 Appliance Server Does Not Start; The Tasksmart W2200 Appliance Server Is Not Working; I Cannot Ping The Tasksmart W2200 Appliance Server From My Client; My Browser Cannot Find The Web Server Configuration Application - Compaq 222863-001 - TaskSmart W2200 Model 10 Administration Manual

A-2 Compaq TaskSmart W2200 Appliance Server Administration Guide

TaskSmart W2200 Appliance Server Does Not Start

The TaskSmart W2200 Appliance Server
Is Not Working
I Cannot Ping the TaskSmart W2200
Appliance Server from My Client
My Browser Cannot Find the
Web Server Configuration Application
I
Press and hold the power button for 4 seconds, and then release.
This action invokes the hardware override for the power button.
I
If the power button override does not solve the problem, reimage the
TaskSmart W2200 appliance server with the Quick Restore CD:
a. Insert the Quick Restore CD into the CD-ROM drive.
b. Power up the TaskSmart W2200 appliance server. The reimaging
process is self-running and takes about 10 minutes.
c. Remove the CD, and then power up the server again.
Most problems are caused by invalid IP address configurations.
Two addresses are critical: a numeric IP address with a subnet mask and a
valid gateway address on the same subnet as the IP address.
The IP Address is Correct and the
TaskSmart W2200 Appliance Server
Still Does Not Respond to a Ping
Some Ethernet cards under Windows NT or Windows 95 do not allow a
cross-over cable. If that is the case, try connecting the two machines with a
standard Ethernet cable running through a hub.
I
Verify that you are using the correct IP address in the URL. Also verify
that you can ping the IP address. A different IP address may have been
established when the server was initialized.
I
Make sure that you specify https:// in the URL window. Typing the
address of the application without https:// does not work.
I
If your browser uses a proxy server, make sure that you added an
exception to the proxy settings for the virtual sites.