HP 680n - JetDirect Print Server Administrator's Manual page 119

Table 4.3 802.11B Configuration Parameters (7 of 7)
Item
Dynamic
TCP/IP
The TCP/IP page provides configuration parameters summarized
in Table 4.4.
Table 4.4 TCP/IP Settings (1 of 4)
Item
IP Configuration
Method
ENWW
Description
For dynamic encryption, you may select one of the following
options:
Basic Encryption: Dynamic WEP encryption is supported.
G
G Robust Encryption: Dynamic Wi-Fi Protected Access (WPA)
and WEP encryption protocols are supported.
When configured for EAP/PSK authentication, the print server
uses Robust Encryption (WPA encryption protocols).
When configured for EAP/802.1x authentication (LEAP only), the
print server should be configured with Basic Encryption.
When configured for EAP/802.1x authentication (PEAP, TLS,
TTLS only), the print server may be configured with either Basic
Encryption or Robust Encryption depending on your network.
Dynamic encryption protocols are under the control of the
authentication server and also must be supported by the Access
Point.
Description
Selects the method that the HP Jetdirect print server will use for
its IP configuration parameters: BOOTP (default), DHCP,
Manual, or Auto IP.
For BOOTP or DHCP, the IP parameters will be automatically
configured by a BOOTP or DHCP server each time the print
server is powered on.
If you select Manual, then basic IP parameters can be manually
entered using this Web page, or using other available tools.
If you select Auto IP, then a unique link-local address 169.254.x.x
will be assigned.
For more information, see Chapter 3.
Using the Embedded Web Server 119