HP 680n - JetDirect Print Server Administrator's Manual page 232

Table 9.12 Error Messages (2 of 11)
Error Code and
Message
09 LAN ERROR -
BABBLE
09 SCANNING FOR
SSID
0A LAN ERROR -
NO SQE
0A LAN ERROR -
OPEN
0C LAN ERROR -
RECEIVER OFF
0D LAN ERROR -
TRANSMITTER OFF
0E LAN ERROR -
LOSS OF CARRIER
0F LAN ERROR - WIRE
FAULT
ENWW
Description
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect print
server. For replacement instructions, see the hardware
installation guide for your print server.
(802.11b Wireless) The print server is scanning on all
channels for devices on the specified SSID (network name).
Check your specified SSID, or check status of the Access
Point (Infrastructure mode) or other wireless devices.
The print server will continue to scan for the specified SSID.
(Wired Ethernet) Check the network connections. If the
connections are intact, run the power-on self-test: turn the
printer off, then on again. If the error persists, replace the
HP Jetdirect print server.
(Token Ring) The HP Jetdirect print server could not insert
into the ring and join the network. Check the data rate switch
on the HP Jetdirect print server to make sure it is set
correctly.
For information on setting the data rate switch, see the
HP Jetdirect internal print server hardware installation
guides. In addition, check the cabling, external transceiver,
wiring concentrator, and taps.
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists after the printer
is turned on again, there is a problem with the HP Jetdirect
print server.
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists, there is a
problem with the HP Jetdirect print server.
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.
(Token Ring) The HP Jetdirect print server has detected an
open or short circuit in the cable between the HP Jetdirect
print server and the Token Ring wiring concentrator. Verify
that this cable is functional and replace it if necessary.
HP Jetdirect Configuration Page 232