HP 680n - JetDirect Print Server Administrator's Manual page 68

Hp jetdirect 200m print server - (english) administrator guide
Hide thumbs Also See for 680n - JetDirect Print Server:
Table of Contents

Advertisement

Once the address appears in the list of IP addresses,
G
select OK. This returns you to the DHCP Options
window. If the address you have just added appears in
the list of IP addresses (near the bottom of the window)
return to step 10d. Otherwise, repeat step 10c.
d. In the DHCP Options window, select WINS/NBT Node
Type (046) from the Unused Options list. Select Add to
add the node type to the Active Options list. In the Byte
box, type 0x4 to indicate a mixed node, and select OK.
11. Click Close to exit to Program Manager.
Windows 2000 Server
To set up a DHCP scope on a Windows 2000 server, perform the
following steps:
1. Run the Windows 2000 DHCP manager utility. Click Start,
then select Settings and Control Panel. Open the
Administrative Tools folder and run the DHCP utility.
2. In the DHCP window, locate and select your Windows 2000
server in the DHCP tree.
If your server is not listed in the tree, select DHCP and click
the Action menu to add the server.
3. After selecting your server in the DHCP tree, click the Action
menu and select New Scope. This runs the Add New Scope
Wizard.
4. In the Add New Scope Wizard, click Next.
5. Enter a Name and Description for this scope, then click Next.
6. Enter the range of IP addresses for this scope (beginning IP
address and ending IP address). Also, enter the subnet mask.
then click Next.
Note
7. If applicable, enter the range of IP addresses within the scope
to be excluded by the server. Then click Next.
ENWW
If subnetting is used, the subnet mask defines
which portion of an IP address specifies the subnet
and which portion specifies the client device. For
more information, see
Appendix
A.
TCP/IP Configuration 68

Advertisement

Table of Contents
loading

Table of Contents