HP 680n - JetDirect Print Server Administrator's Manual page 61

Hp jetdirect 200m print server - (english) administrator guide
Hide thumbs Also See for 680n - JetDirect Print Server:
Table of Contents

Advertisement

Table 3.3
TFTP Configuration File Parameters (8 of 10)
ipx-banner:
Enables or disables printing an IPX banner page. 0 disables banner pages.
1 (default) enables banner pages.
ipx-eoj:
Enables or disables IPX end-of-job notification. 0 disables, 1 (default) enables.
ipx-toner-low:
Enables or disables IPX toner-low notification. 0 disables, 1 (default) enables.
AppleTalk
appletalk:
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server:
0 disables, 1 (default) enables.
name-override:
(External print servers only) Specifies the name of the AppleTalk network. Up to
32 characters may be used.
DLC/LLC
dlc/llc:
Enables or disables DLC/LLC protocol operation on the print server: 0 disables,
1 (default) enables.
Other Settings
link-type:
(10/100 Fast Ethernet) Sets the print server's link speed (10 or 100 Mbps) and
communication mode (Full- or Half-Duplex). Selections are AUTO, 100FULL,
100HALF, 10FULL, 10HALF.
For AUTO (default), the print server uses autonegotiation to determine the link
speed and mode. If autonegotiation fails, then 100HALF is set.
webscan-config:
Enables or disables the Web Scan feature on the print server when connected to
a supported device. 0 disables, 1 (default) enables.
scan-idle-timeout:
Specifies the number of seconds (1 - 3600) that an idle scan connection is allowed
to remain open. 0 disables the timeout. The default is 300 seconds.
scan-email-config:
Enable or disable the scan-to-email feature in the Web Scan server. 0 disables,
1 (default) enables.
ENWW
TCP/IP Configuration 61

Advertisement

Table of Contents
loading

Table of Contents