HP 680n - JetDirect Print Server Administrator's Manual page 240

Hp jetdirect 200m print server - (english) administrator guide
Hide thumbs Also See for 680n - JetDirect Print Server:
Table of Contents

Advertisement

Table 9.12
Error Messages (10 of 11)
Error Code and
Message
53 BAD BOOTP
TAG SIZE
54 BOOTP/RARP
IN PROGRESS
55 BOOTP/DHCP
IN PROGRESS
56 DHCP NAK
57 UNABLE TO
CONNECT DHCP SVR
58 POSTSCRIPT
MODE NOT
SELECTED
59 INCOMPLETE F/W -
MUST DOWNLOAD
5A TURN PRINTER
OFF / ON
5C DHCP BAD REPLY
5D DHCP LEASE
DURATION TOO
SHORT
5E DHCP LEASE
RELEASED
5F WINS
REGISTRATION
FAILED
61 AUTO IP
CONFIGURED
ENWW
Description
The tagsize in a vendor-specific field in the BOOTP reply
is either 0, or greater than the remaining number of
unprocessed bytes in the vendor-specified area.
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/RARP.
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/DHCP, and has not detected any errors.
The HP Jetdirect print server received a negative
acknowledgement message from the DHCP server in
response to a configuration request.
The HP Jetdirect print server had received IP parameters
from a DHCP server, but communication with the DHCP
server has been lost. Check status of the DHCP server.
If an infinite lease was assigned, the print server will use the
IP address of the most recent DHCP server used, but
operation may be degraded until a DHCP server responds.
The printer does not support AppleTalk or AppleTalk
extensions.
Firmware download message. Currently downloading
firmware to the HP Jetdirect print server, or the download
did not complete properly.
Firmware download message. Download of firmware is
complete. Power off/on the HP Jetdirect print server.
A bad reply was received from the DHCP server. Check your
DHCP server settings for this print server.
The DHCP lease times for this print server's TCP/IP
configuration settings are too short. Reconfigure the DHCP
lease times on the DHCP server.
The lease for DHCP-configured parameters, including the
IP address, have been released through a manual
configuration method, such as through the printer's control
panel.
Attempts to register the print server's name on the WINS
server failed. Check for duplicate names, or verify the WINS
server configuration.
An IP address could not be retrieved over the network. The
print server will default to an IP address using link-local
addressing in the form 169.254.x.x.
HP Jetdirect Configuration Page 240

Advertisement

Table of Contents
loading

Table of Contents