ITech IT6341C User Manual page 38

Para (output parallel setting)

Select this item to set CH1 and CH2 to parallel mode, press
confirm the selection, press
After pressing
2S is displayed, the system automatically exits the menu.
Parallel Terminal Wiring
In the power supply output OFF state, connect the positive terminals of
CH1 and CH2 to the positive terminal of the object to be measured,
respectively, and connect the negative terminals of both CH1 and CH2 to
the negative terminal of the object to be measured.
Note: The voltage used in parallel must not exceed the rated voltage of
CH1 by more than 5V.
Track (output synchronization setting)

Select this item to set CH1 and CH2 to synchronized mode, press
to confirm the selection, press
Before this setting, you need to set the voltage and current of the selected
channel. After selecting Synchronization, if any parameter is changed, the
corresponding parameter
proportionally.
Set CH1 and CH2 to synchronized status, the panel will prompt "Track
Set Success! After displaying 2S, the system will exit the menu
automatically.
Note
If the set voltage/current value of the synchronized channel is zero before
synchronization, the synchronization operation of the channel voltage/current is
ignored.
The Output Timer setting will be Disable when the Serial Parallel or
Synchronized state is selected.
Copyright © Itech Electronic Co., Ltd.
to exit the selection.
, the panel will prompt " Parallel Success!". After
of other channels
Function and Features
to exit the selection.
will be changed
to
29