ITech IT6341C User Manual page 18

delivery standards and is available for normal usage.
Before operation, please confirm that you have fully understood the safety
instructions.



Selftest steps
Normal selftest procedures:
1. Correctly connect the power cord. Press Power key to start up.
2. After selftest, VFD display information as follows:
Error Information References
The following error information may occur when an error occurs during Power
On self-test:






To avoid burning out, be sure to confirm that power voltage matches with
supply voltage.
Be sure to connect the main power socket to the power outlet of
protective grounding. Do not use terminal board without protective
grounding. Before operation, be sure that the power supply is well
grounded.
To avoid burning out, pay attention to marks of positive and negative
polarities before wiring.
0.000V 0.000V
0.000A 0.000A
If the EEPROM was damaged, the VFD will display
If the latest operation state of the power supply was lost, then the VFD will
display System Lost
" "
If send channel data, the channel response failure, the VFD display the
tooltip information Model Fail
"
If calibration data read failure, the VFD display the tooltip information "Cal
Lost".
If the channel to send data loss, channel initialization failed, the VFD
display the tooltip information
If the factory calibration data in EEPROM is lost, and then the VFD will
display FACT LOST
" "
Copyright © Itech Electronic Co., Ltd.
.
.
"
Model Lost .
" "
.
Quick Start
EEPROM Fail .
" "
9