ITech IT6341C User Manual page 32

voltage and output current settings after the power supply is turned on are
always 0V and 0A; if Keep option is selected, the output voltage and current
settings after the power supply is turned on are set to the values set when the
power supply was last turned off. The factory setting is RESET option.
Output state setting after power-on (P-OUT)
This menu item allows you to set the state of the outputs after the power
supply is re-powered. If the KEEP option is selected, the output after the
power supply is turned on maintains the output state from the last power off. If
the OFF option is selected, the output of the power supply after power on is
always OFF. the factory setting is OFF option.
Communication mode setting (COMM)
This option sets the specific communication mode of the power supply. This
power
communication interfaces, and optional RS232 and GPIB communication
interfaces.
Keyboard Sound Settings (Buzzer)
This menu item sets whether the buzzer sounds when the keypad is pressed.
With the ON option, the buzzer sounds when a keypad is pressed; with the
OFF option, the buzzer does not sound. The factory setting is the ON option.
Knob Status Setting (KNOB)
This option is used to set whether the pulsation knob can be used or not. If it is
the Unlock option, the knob can be utilized for value setting and menu
selection; if it is the LOCK option, the knob will be locked and cannot be used.
The factory setting is the Unlock option.
Trigger mode selection (TRIG)
This option is used to set whether the trigger signal is keyboard triggered or
command triggered or external signal triggered during LIST operation.



The factory setting is the MANU option.
supply comes
With the MANU option, the trigger signal is provided by the panel
composite key (Shift) +
If the BUS option is selected, it is command triggered mode (*TRG trigger
command);
If it is the EXT option, it is the external signal trigger mode, i.e., the
following Trig terminal on the rear panel triggers a LIST run when it
receives a low level signal once.
Copyright © Itech Electronic Co., Ltd.
standard with USB-TMC,
(Trigger);
Function and Features
USB-VCP, LAN
23