Infors HT ECOTRON Manual page 40

08 May 2013
Max shaking speed
Angabe Wert
25 up to Max. 200 rpm
750 mL
1000 mL Max. 250 rpm
2000 mL Max. 250 rpm
3000 mL Max. 300 rpm
5000 mL Max. 250 rpm
13. Components from Suppliers
All the components from suppliers have been tested before the constructional implementing into
the INFORS product. As a general rule INFORS uses only proven components.
In exceptional cases faults may still occur in suppliers' products. In such cases INFORS cannot
take any liability leading further than the normal warranty. We kindly ask the customer for
understanding and will of course do our best to keep the highest quality standard possible.
The above mentioned exclusion of liability is not effective for safety issues.
(Operating-Manual_Ecotron _e)
Changing the adhesive matting:
Thoroughly wet the tray
Release Adhesive Matting on a side and pull obliquely away from the tray.
Degrease tray with Acetone and apply new matting with water (see
installation instructions). Do not remove protective foil until first use.
0
The Adhesive Matting is reusable and can be applied again after regeneration
in water.
Maximum shaking speeds are only valid on condition that:
Only original Schott Duran Erlenmeyer flasks with 20% filling volume and
paper- or cotton stoppers are used. Plastic Erlenmeyer flasks are not
appropriate for use with the adhesive matting.
Glass and Adhesive matting must be totally undamaged, clean, dry and
free of grease.
All information supplied without liability.
Data in the left column are valid for 50 mm shaking diameter. With 25 mm
shaking diameter, slightly higher shaking speeds are possible
page 40 of 53