Infors HT ECOTRON Manual page 38

08 May 2013
11.5 ECOTRON ® Fuses
Fuses are exchanged in the following way:
Switch the unit off and withdraw the power cable
-
Withdraw the fuse holder located in the power socket on the back of the unit using a screwdriver.
-
- Replace the fuses (2 quick-blowing 250 V; T 5 A or. 2 quick-blowing 115 V; T 8 A)
In the event that the fuses blow again, the user MUST contact their nearest Infors supplier
11.6 Incubation chamber lighting: Exchanging the bulb
In the event of a problem with the incubation chamber lighting, you must take the following steps:
Switch off and withdraw the power cable
-
- Remove the electronics box (see Chapter 11.1)
Remove the bulb(s) through the ventilation slits on either side of the electronics box.
-
- Insert a new bulb (12, 10W), without touching it with your bare hands as this will considerably
reduce its working life!
- Replace the electronics box.
Fig. 16: Removing the bulb(s) for incubation chamber lighting through the side ventilation slots.
CAUTION: When temperature control has been switched on, the bulb and heating element
can become hot! In this case, the electronics box must first be allowed to stand for a time to
cool.
The bulbs are connected in series, therefore when one bulb is defective the other will not light
also.
12. Additional equipment, Options
A detailed list of all possible options and accessories can be obtained from your nearest INFORS
dealer.
(Operating-Manual_Ecotron _e) page 38 of 53