Infors HT ECOTRON Manual page 21

08 May 2013
NOTE:: Entered set points are not validated and no direct confirmation of the input is
provided. Don't forget that the parameter must be switched ON for the control lfunction related
to a set point to be activ
Switching the temperature control ON and OFF
You can control the temperature of the incubation chamber of the
Ecotron®, from approximately 5 °C above room temperature up
to 65 °C. If the optional cooling is available, temperatures down
to approximately 10°C under room temperature can be attained.
Check that the main power switch in the middle of the operating
panel is ON (see Chapter. 7.1).
The incubation chamber light is switched on for 2 minutes at the
first touch of any key.
Press the right hand ON/OFF key to turn on the temperature
control. After pressing the key, the temperature display will briefly
show if this function is switched on or off.
The controller begins to work after the incubation chamber door
has been closed..
If the door is open, the temperature display will show "OPn".
While temperature control is switched on and operational (door
closed), the actual temperature is displayed. If this function is
switched off and the door is closed, then the display alternates
between OFF and the set point value.
On pressing the ON/OFF key, the machine is lit for 2 minutes.
The set point display changes after 2 seconds to either show on or off, depending on the
contoller status.
(Operating-Manual_Ecotron _e) page 21 of 53
+
O F F
O F F
O F F
-
°C
+
O N
O N
O N
-
°C
+
3 7
3 7
3 7
-
°C
x1