Infors HT ECOTRON Manual page 17

08 May 2013
4.2 Chemical Resistance
The housing was tested with different solvents. With the solvents listed below neither a relevant change
of weight nor a change of the Shore D-hardness was found:
- water
- inorganic acids: phosphorus, nitric, hydrochloric or sulphuric acid, watery 10%
- organic acids: formic, acetic and lactic acid, watery 10 %
- inorganic bases: soda lye, at 10 % solution (aqueous)
-
inorganic chemicals in aqueous solution: hydrogen peroxide 10 %, calcium chloride saturated
solution, bleaching lye solution concentrated
-
hydrocarbons: fuel, motor oil, diesel
The housing should not be exposed to the following solvents in large quantities nor over a long
period of time:
- methanol
- ethanol
- acetone
- cyclohexanone
- ethyl acetate
- ethylglycolacetate
- methylenchloride
The door window can be cleaned with a damp cloth and a normal neutral cleaner.
5. Interfaces
5.1 Electricity
Sparkplug with a double protective system ("Europlug")
230 (115) Volt ± 10 %
50 (60) Hz
5.2 Drain
The drain is located in the front of the housing beneath the door under a closure (see chapter
10.3).
Outlet: lightweight pipe 11 mm diameters.
(Operating-Manual_Ecotron _e) page 17 of 53