Points For Using Adhesive Matting "Sticky Stuff - Infors HT ECOTRON Manual

08 May 2013
12.1 Points for using INFORS Adhesive Matting «Sticky Stuff»
(Operating-Manual_Ecotron _e)
Always use protective goggles and gloves while handling
glassware!
Only use containers with a wide, flat base. Large Erlenmeyer
flasks (e.g. 3000 mL) will stick stronger than small ones (e.g. 100
mL).
Before putting on the INFORS reagent tube holders, clean the
Sticky Stuff to ensure the maximum adhesive power.
Before putting on containers:
Check that bottom is dry and clean
Check flask for any damages: never use damaged flasks!
Before shaking:
Tug gently to ensure each flask is stuck.
Keep in mind that formation of condense water might occur at low
temperatures or using the timer function, possibly causing accidental
release of containers.
To remove flask:
Push or pull neck gently and evenly and wait a few seconds. Do not use
much power!
With large containers, it can take up to 30 seconds until flask is released.
Flasks which are firmly attached can be released with water:
Simply apply water with a syringe to the bottom.
Especially Fernbach-flasks are difficult to remove because of their geometry
(large bottom, short neck), therefore cover the adhesive matting partly with the
protective foil supplied with each new tray.
The adhesive power will diminish gradually, due to dust and dirt sticking on the
surface. To regenerate proceed as follows:
Clean regularly with water and mild detergent. Shrub vigorously with a
brush or hard sponge. Do NOT use solvents!
Let dry over night
Disinfect with 70% ethanol or usual disinfectants.
Do not exceed specified treatment times and rinse thoroughly with water. If
disinfection is done routinely, it might be necessary to replace the Sticky Stuff
earlier.
It is possible to apply the Green Adhesive Matting "Sticky Stuff®" to universal
trays.
page 39 of 53