Kyocera ECOSYS MA2600cwx Operation Manual page 502

System Menu > Security Settings
Item
[Software Verification]
[Authentic. on FW Update]
[Allowlisting]
[Data Security]
[System Menu/Counter] key > [Security Settings] > "Device Security Settings " [Data Security]
Configure settings related to data stored in SSD or memory.
[SSD Initialization]
Change the security feature settings.
NOTE
• This feature appears when an optional SSD is installed and the optional security kit is running.
• To change security feature settings, you must enter a security password. The factory default value is
000000.
Verify the software in the machine.
Select [Start] to run the verification.
If you experience any abnormalities in software verification, contact
your service representative.
Request administrator to approve when updating firmware.
Value: [Off], [On]
In case if the unauthorized program or the program that has tampered
are installed, the stored data or the contents of the communication in
this program might be stolen. Once this function is activated, execution
of the unauthorized software or the tampering of the software can be
prevented, and possible to maintain the reliability of the system.
Value: [Off], [On]
NOTE
• After setting it to [On], you need to shut down and restart the
machine.
• Enabling this feature slows the machine start-up.
• If malware is detected, an event report can be used as a way
to understand its content. The Event reports can be enabled by
the Command Center RX > "Management Settings: Notification/
Report" > [Recipient 1 E-mail Address] to [Recipient 3 E-mail
Address] and [Notify when Malicious Program is Detected] is set
to [On].
493
Description