Kyocera ECOSYS MA2600cwx Operation Manual page 489

System Menu > Network Settings
[VNC (RFB) over TLS]
Item
[Protocol Settings]
[Available Network]
[Enhanced VNC (RFB) over TLS]
Item
[Protocol Settings]
[Available Network]
*1 The setting will be changed after restarting the device or network.
*2 In "SecuritySettings" set [TLS] to [On].
➡
Network (page 499)
IMPORTANT
Depending on the protocol, it may be necessary to restart the network or turn the power off/on after
changing the settings.
Set when using a remote operation protected by TLS by starting up
a VNC Viewer other than ours (example: Real VNC). The default port
*1*2
number is 9063.
Value: [Off], [On], 1 to 32767 (Port Number)
NOTE
When the setting is On, TLS certificate is required. The factory
certificate is the certificate owned by the machine.
Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Start Command Center RX and set for using TLS-protected remote
operation. The default port number is 9061.
Value: [Off], [On], 1 to 32767 (Port Number)
NOTE
• The factory default setting is [On].
• When the setting is On, TLS certificate is required. The factory
certificate is the certificate owned by the machine.
➡ Command Center RX User Guide
Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
480
Description
Description
*1*2