Installation; Overview; Safety Precautions - Ametek BrightTEK ST9 Series Operator's Manual

41-622 BrightTEK ST9x Operator Manual
™
2.0

Installation

2.1

Overview

The BrightTEK ST95 Cellular Uplink Host is available
alongside LMS level sensors or can be purchased
separate and integrating with existing LMS sensors al-
ready in use. The uplink interfaces to industry standard
4–20mA devices and may be used with Programmable
Logic Controllers or other such devices. The uplink
ships pre-wired with 50 feet of cable to allow installation
of the ST95 Uplink Client in a convenient location. This
is desirable especially for battery changes where tanks
are high and difficult to get to without a ladder or lift.
Carefully follow and adhere to the instructions below.
The ST95 Uplink Client must be mounted in a location
where it will be protected from activities which may
subject it to damage. A mounting kit has been selected
to firmly secure it to your chosen location.
The ST95 Cellular Uplink Host or the ST95 Uplink Client
may be used in this product. Determine which type
you have to avoid communications issues. A host uses
cellular signals like a Cellphone and needs to have
cellular coverage wherever it is located. Likewise, the
client needs to talk to the host that it is assigned to. It
has a limited range that it can communicate over. If you
are not familiar with wireless devices, contact AMETEK
LMS Customer Support at fieldservice.magnetrol@
ametek.com.
2.2

Safety Precautions

• This product must be installed and maintained in strict
accordance with the National Electrical Code and any
other applicable local electrical code. Refer to the Sys-
tem Control Drawing (906-00017) in the appendix of this
manual for specific installation information. Failure to
observe this warning could result in serious injuries or
damages.
• If you are not familiar with Industrial Hazardous Loca-
tion Standards, consult with a safety expert before you
attempt to install this device.
5