Read this Manual Before Installing
This manual provides information on the BrightTEK tank
monitoring system. It is important that all instructions
are read carefully and followed in sequence.
Conventions Used in this Manual
Certain conventions are used in this manual to convey
specific types of information. General technical
material, support data, and safety information are
presented in narrative form. The following styles are
used for notes, cautions, and warnings.
NOTES
Notes contain information that augments or clarifies
an operating step. Notes do not normally contain
actions. They follow the procedural steps to which
they refer.
Cautions
Cautions alert the technician to special conditions
that could injure personnel, damage equipment,
or reduce a component's mechanical integrity.
Cautions are also used to alert the technician to
unsafe practices or the need for special protective
equipment or specific materials. In this manual,
a caution box indicates a potentially hazardous
situation which, if not avoided, may result in minor
or moderate injury.
WARNINGS
Warnings identify potentially dangerous situations
or serious hazards. In this manual, a warning
indicates an imminently hazardous situation which,
if not avoided, could result in serious injury or death.
FCC Statement
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device must not be allowed to cause
harmful interference
2. This device must accept any interference
that may cause undesired operation.
WARNING – For Your Safety
• Read these installation and operation
instructions carefully. Failure to follow these
instructions may result in death or serious
injury.
• Only qualified service personnel must install
or repair this equipment.
Caution: The battery pack used in this device
may present a fire or chemical burn hazard if
mistreated. Do not recharge, disassemble, heat
above 100 °C (212 °F) or dispose of in fire. Re-
place Battery pack with AMETEK LMS P/N 089-
WRL9-001 only. Use of another battery pack
may present a risk of fire or explosion.
• Do not open the housing unless the area is
known to be non-hazardous. Remove the
Electronics Caddy from the hazardous area
prior to changing the battery pack. Refer to
section 2.0 for installation details.
• Substitution of parts may impair the intrinsic
safety of this equipment.
• This equipment must be installed in accor-
dance with local requirements and the Nation-
al Electric Code.
Warranty
BrightTEK products are warranted free of defects in
materials or workmanship for one year from the date
of original factory shipment.
If returned within the warranty period; and, upon
factory inspection of the control, the cause of the
claim is determined to be covered under the warranty;
then, AMETEK LMS will repair or replace the control
at no cost to the purchaser (or owner) other than
transportation.
AMETEK LMS shall not be liable for misapplication,
labor claims, direct or consequential damage or
expense arising from the installation or use of
equipment. There are no other warranties expressed
or implied, except special written warranties covering
some AMETEK LMS products.
Copyright © 2024 AMETEK Magnetrol USA, LLC
Performance specifications are effective with date
of issue and are subject to change without notice.
AMETEK LMS reserves the right to make changes
to the product described in this manual at any time
without notice. AMETEK LMS makes no warranty
with respect to the accuracy of the information in this
manual.
41-622 BrightTEK
ST9x Operator Manual
™
Need help?
Do you have a question about the BrightTEK ST9 Series and is the answer not in the manual?