Infors HT Multitron Operating Manual page 94

Multitron - Operating manual
Operation
Set Brake Power
Illumination
Button Sounds
Altitude and CO
2
Timer
Page 94 of 140
Setting the braking power with which the shaker drive is stopped
when the "Rotation speed" parameter is switched off.
At brake force level 0 the shaking table is stopped by reducing the
■
rotation speed very slowly.
At brake force level 1 the shaking table is also controlled but
■
stopped a little less slowly.
At brake force level 2 a passive brake is activated by switching off
■
the motor.
At brake force level 3 the motor is short-circuited to stop the
■
shaking table as quickly as possible.
The brake force setting is effective only when the
"Rotation speed" parameter is switched off manually,
but not when the door is opened. When the door is
opened, the shaking table is automatically stopped
with the maximum brake force, regardless of which
brake force has been set. To activate the brake
force setting, always deactivate the "Rotation speed"
parameter first, before opening the door.
Setting the behaviour of the working light.
Auto : The working light is switched on by pressing any key or when
■
the door is opened. After 2 minutes the working light switches off
again automatically.
ON : The working light is switched on permanently.
■
OFF : The working light is switched off permanently.
■
The brightness of the display is synchronised with the
working light of the device. As soon as the working
light is switched off, the brightness of the display is
reduced.
Activating or deactivating the key sound (clicking sound when
pressing a key).
The digital CO sensor GMP251 is pressure-dependent. To achieve pre-
2
cise measuring results, the altitude of the device's location can be set.
Activating or deactivating the timer function. If the timer function is
OFF , it can no longer be selected by using the Timer key.
set to
27.05.2024