Increasing System Storage And Memory; Hard Disk; Removing And Installing A Hard Disk Drive - NEC VERSA 5000 Series User Manual

For the infrared technology to work, follow these guidelines:
T
position the NEC Versa no more than three feet away
from the IR peripheral device you are using
T
keep the computer and the device IR ports aligned.
The LapLink software that ships with your NEC Versa
system provides ways for you to use the IR port. Read the
instructions in Chapter 2 under "How to Use LapLink" for
steps on using the software with the IR port.

INCREASING SYSTEM STORAGE AND MEMORY

As your needs grow and change, you may need to add an
optional hard disk drive with a greater capacity or addi-
tional memory. Read the following sections to learn how to
install an optional hard disk drive or a memory module.

Hard Disk

You can increase the system's storage capacity by replacing
the standard hard disk drive with a drive that offers greater
storage capacity.

Removing and Installing a Hard Disk Drive

Make sure your NEC Versa is powered off, all external op-
tions are disconnected, and the LCD panel is closed. Then
proceed as follows to replace the hard disk drive.
NOTE
the hard drive is being removed and installed.
Verify that all peripheral devices and cables are discon-
1.
nected from your system. Check that the LCD panel is
closed and latched. Make sure the system is powered off.
The NEC Versa must be powered off while
Using Your NEC Versa 4-23