NEC VERSA 5000 Series User Manual page 16

T
Power Button — The Power button is located on the
chassis just below the LCD. It turns NEC Versa 5000
power on and off. Press the button to turn power on;
press it again to turn power off.
When power is on, the Power LED to the right of the
Power button lights. (The Power LED is the left-most
LED in the row of LEDs.) See "Setup Parameters" in
Chapter 3 for information about defining this button as a
Suspend/Resume button.
If your system is in Suspend mode or has gone into Save
to Disk mode, pressing the Power button puts the system
in Operation mode.
NOTE
After turning off the system, wait 5 seconds
before turning it back on. This gives system compo-
nents a chance to power down properly.
T
The Battery/Charging Status LED is located on the
right-hand LCD hinge and lights to indicate the
following:
Green – the battery is fully charged and the system
is connected to AC power.
Amber – the battery is recharging.
Off – the AC adapter is disconnected or the battery
is not installed.
Getting Started 1-5