Table of Contents
Advertisement
For the infrared technology to work, follow these guidelines:
T
position the NEC Versa no more than three feet way
from the IR peripheral device you are using, also
T
keep the IR ports between the computer and the device
parallel.
The LapLink software that ships with your NEC Versa
system provides ways for you to use the IR port. Read the
instructions in Chapter 2, "How to Use LapLink," for steps
on using the software with the IR port.
INCREASING SYSTEM STORAGE AND MEMORY
As your needs grow and change, you may need to add an
optional hard disk drive with a greater capacity or addi-
tional memory. Read the following sections to learn how to
install an optional hard disk drive or a memory module.
Hard Disk
You can increase the system's storage capacity by replacing
the standard hard disk drive with a drive with greater stor-
age capacity. See the section "Drive Bays" for details about
removing a hard disk drive and adding a new one. After you
install the drive, you may need to go into Setup to specify
your new drive type.
Installing a Memory Module
Your NEC Versa comes standard with either 8 or 16 mega-
bytes (MB) of Extended Data Out (EDO) memory. This
new technology gives your system higher performance. You
can increase system memory to a maximum of 40 MB by
installing two double inline memory modules (DIMM) in
the system.
The following module capacities are available:
T
8-MB memory module
Using Your NEC Versa 4-25
Advertisement
Table of Contents
