Table of Contents
Advertisement
Expansion Board Removal
Remove any installed expansion board(s) per the following steps.
1.
Remove the system unit cover (see "System Unit Cover Removal" earlier in this
section).
2.
If you have any cables connected to the board that you need to remove, label the
connectors before you remove them.
Remove the screw that secures the board to the support bracket (see Figure
3.
Section 5-4).
Pull the board out of the connector. You might have to gently rock the board
4.
from side-to-side to release it from its connector.
SIMM Removal
Remove any optional SIMM sticks from the system board as follows.
1.
Remove the system unit cover as previously described (see "System Unit Cover
Removal").
Figure Section 5-4 Expansion Board Removal
CAUTION: Reduce static discharge by touching
the system's metal chassis.
Repair
5-5
Advertisement
Table of Contents
Troubleshooting
