NEC POWERMATE PRO2180 - SERVICE MANUAL 1996 Service Manual page 73

Serial Port (1 and 2) Address
The serial ports 1 and 2 may be "Auto" detected or "Disabled." The default is "Auto."
When "Auto" is selected, the first free COM port is assigned regardless of what is selected.
The serial COM port and addresses are as follows. When an option is selected for one serial
port, the selection is not available for the second port.
n
Disabled
n
COM1, 3F8h
n
COM2, 2F8h
n
COM3, 3E8h
n
COM4, 2E8h
Serial Port 2 IR Mode
The Serial Port 2 IR Mode field allows you to dedicate Serial Port 2 for Infra-red
applications. This field can be either "Enabled" or "Disabled." The default is "Disabled."
Parallel Port Address
The parallel ports may be "Auto" detected or "Disabled." The default is "Auto." When
"Auto" is selected, the first free LPT port is assigned regardless of what is selected. The
parallel port address options are as follows.
n
Disabled
n
LPT3, 3BCh
n
LPT1, 378h (default)
n
LPT2, 278h
n
Auto
Parallel Port Mode
The Parallel Port Mode field options are as follows.
n
Compatible sets the parallel port to the standard AT compatibility.
n
Bi-directional (default)
n
ECP sets the parallel port to the Enhanced Capabilities Port (ECP) mode.
n
EPP sets the parallel port to the Enhanced Parallel Port (EPP) mode.
sets the parallel port to input/output mode only.
Setup and Operation 2-33