Disassembly And Reassembly; Section 5 Repair Disassembly And Reassembly; Powermate Pro2200/2180 Series System Unit Disassembly Sequence - NEC POWERMATE PRO2180 - SERVICE MANUAL 1996 Service Manual

Section 5
Repair

DISASSEMBLY AND REASSEMBLY

This section contains step-by-step disassembly procedures for the system unit. Reassembly
is the reverse of disassembly. Each procedure is supported by a simplified disassembly
illustration to facilitate removal. The detailed exploded-view diagram and parts lists for the
systems are included at the end of this section.
A Phillips-head screwdriver is the only required tool. For complete disassembly of the
system unit, follow the disassembly order listed in Table Section 5-1. To reassemble, follow
the table and procedures in reverse order.
Individual removal procedures do not require the total disassembly of the computer. Each
of the following subsections lists the parts that must be removed before beginning the
removal procedure.
Table Section 5-1 PowerMate Pro2200/2180 Series System Unit Disassembly
Sequence Part
1 System unit cover
2 Side panel
3 Expansion board(s)
4 SIMM sticks
5 Front panel assembly
6 Blank panel and metal cover plate
8 3 1/2-inch diskette drive
9 3 1/2-inch hard disk drive
10 5 1/4-inch device
11 Power supply
12 System board
Sequence
See Page
5-2
5-4
5-4
5-5
5-7
5-7
5-8
5-10
5-11
5-13
5-14