Scsi Devices; Connecting An Rs-232C Cable - NEC POWERMATE PRO2180 - SERVICE MANUAL 1996 Service Manual

3-36 Option Installation
2. Connect one end of the serial cable to one of the two serial ports on the rear of
the computer.
3. Secure the cable with the screws provided.
Connect the other end to the serial device.
4.
Figure Section 3-31 Connecting an RS-232C Cable

SCSI Devices

Connect an external SCSI device to the back of the system unit as follows.
Make sure the power to the system unit and SCSI device are off.
1.
2. Connect one end of the SCSI cable to the SCSI ports on the rear of the computer.
3. Secure the cable with the screws provided.
NOTE: Before connecting a SCSI device to the
system, be sure the SCSI device is set up
correctly, including the SCSI ID. Follow the
setup instructions that come with the option.
S e r i a l P o r t 1 S e r i a l P o r t 1
S e r i a l P o r t 2 S e r i a l P o r t 2
S c r e w s S c r e w s
R S - 2 3 2 C C a b l e R S - 2 3 2 C C a b l e