Replacing The Access Cover; Figure 3-1 Releasing The Cover; Figure 3-2 Aligning The Tabs - NEC DIRECTION SP B - SERVICE MANUAL 1998 Service Manual

3-4 Option Installation
5. Lift the access cover off the system.

REPLACING THE ACCESS COVER

To replace the access cover, use the following procedure.
Gently set the access cover inside the edge of the case, taking care not to bend the
1.
metal tabs.
Align the tabs on the access cover with their corresponding slots on the system.
2.
Insert the tabs on the edge of the access cover into their slots on the system.
3. Slide the access cover forward to meet the front panel.
Tighten the thumb screw.
4.

Figure 3-1 Releasing the Cover

Figure 3-2 Aligning the Tabs