NEC DIRECTION SP B - SERVICE MANUAL 1998 Service Manual page 27

T
Parallel Port
This option configures the system's Parallel Port. Choose "Auto" (default),
"Enabled," or "Disabled." The "Auto" setting causes the Setup program to assign
LPT 1, 378h, IRQ7.
T
Mode (Parallel Port)
This option sets the mode for the parallel port. The options include "Output Only"
(AT-compatible mode), "Bidirectional" (PS/2-compatible mode), "EPP"
(Extended Parallel Port – high speed bidirectional), and "ECP" (Enhanced
Capabilities Port – high speed bidirectional).
T
Audio
This option configures the onboard audio system. Select "Enabled" (default) or
"Disabled."
T
Legacy USB Support
This option configures support for legacy USB devices. Select "Enabled" or
"Disabled" (default).
To return to the Advanced Menu, press
NOTE: If you select the Enabled option, you can
see additional options that allow you to specify
the Base I/O address and IRQs for the port you
are configuring.
NOTE: If you select the Enabled option, you can
see additional options that allow you to specify
the Base I/O address and IRQs for the port you
are configuring.
!
CAUTION: An asterisk symbol
appearing next to an option indicates that the
selected IRQ is set to conflict with another
device.
Esc
.
Setup Utility 2-7