Download Print this page

Connecting The Module To Mains Power - GSi GRAINVUE User Manual

Fan control module
Hide thumbs Also See for GRAINVUE:

Advertisement

Chapter 2: Installing the Fan Control Module

Connecting the Module to Mains Power

NOTE: Your system will come with either 8 relays (part # 074-11980) or an 8 channel logic driver (Part #
074-11983) for fan control. The fan control method was determined at the time of ordering. If the
fan control method must be changed, please contact GrainVue:
Email: grainvuesupport@agcocorp.com or
Phone: 1-306-490-2446
Only a certified electrician can complete the power supply installation. Make sure all
power sources are disconnected before performing any maintenance or service.
WARNING
Always follow all national and local electrical and safety regulation for your area.
1. Remove the pre-installed knockout plug (20) (for power cable), circled in red.
Figure 2-10 Removing the knockout plug
Knockout plug (for power cable)
20
22
PNEG-2394 Fan Control Module

Advertisement

loading
Need help?

Need help?

Do you have a question about the GRAINVUE and is the answer not in the manual?

Subscribe to Our Youtube Channel