Table of Contents
Advertisement
60
3
Fig. 37
1
The air bleeding operations in the front braking system
must be carried out in the following order:
‹
Remove the protection cap of the air valve of the
pliers (2) and insert the end of a transparent flexible
tube (1).
The other end is to remain free inside a receptacle
(3).
‹
Remove the cap of the brake oil tank and check that
the oil is at the maximum level: if necessary, refill
with oil (see "Lubricants chart" - page 85).
‹
Slowly and fully pull (2 -3) the control lever; keep
the lever pulled, open the air valve (2) until the oil,
or even air bubbles, begin coming out from the
tube.
‹
Shut the valve and release the brake lever.
‹
Repeat the operation described above until no more
air bubbles, visible in the oil, come out from the
valve.
‹
Screw up the valve (2) remove the flexible tube (1)
carefully avoiding staining with oil the pads or the
disc.
‹
Put back the protection cap, refill the tank up to the
maximum level and carefully close it.
Hide quick links:
Advertisement
Table of Contents
