Snmp Traps; Table 24-2 Snmp Traps; Table 24-3 Ports And Permanent Virtual Circuits - ZyXEL Communications Prestige 861H-G1 User Manual

FIELD
Trusted Host If you enter a trusted host, your Prestige will only respond to SNMP
messages from this address. A blank (default) field means your
Prestige will respond to all SNMP messages it receives, regardless
of source.
Trap:
Community Type the trap community, which is the password sent with each trap
to the SNMP manager.
Destination Type the IP address of the station to send your SNMP traps to.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

24.4 SNMP Traps

The Prestige will send traps to the SNMP manager when any one of the following events occurs:
TRAP # TRAP NAME
1 coldStart (defined in RFC-1215)
2 warmStart (defined in RFC-1215)
3 linkDown (defined in RFC-1215)
4 linkUp (defined in RFC-1215)
5 authenticationFailure (defined in
RFC-1215)
6 whyReboot (defined in ZYXEL-
MIB)
6a For intentional reboot :
The port number is its interface index under the interface group.
SNMP Configuration
DESCRIPTION

Table 24-2 SNMP Traps

A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent with the port number when any of the links
are down. See the following table.
A trap is sent with the port number.
A trap is sent to the manager when receiving any SNMP
gets or sets requirements with wrong community
(password).
A trap is sent with the reason of restart before rebooting
when the system is going to restart (warm start).
A trap is sent with the message "System reboot by user!" if
reboot is done intentionally, (for example, download new
files, CI command "sys reboot", etc.).

Table 24-3 Ports and Permanent Virtual Circuits

PORT PVC (PERMANENT VIRTUAL CIRCUIT)
1 Ethernet LAN
2 1
3 2
... ...
13 12
14 xDSL
Prestige 861H User's Guide
EXAMPLE
0.0.0.0
public
0.0.0.0
DESCRIPTION
24-3