Rear Panel - ZyXEL Communications EX3301-TO User Manual

Amber

2.4. Rear Panel

The connection parts are located on the rear panel of the Zyxel device.
The following table describes the ports and buttons of the rear panel:
Ports/Buttons
POWER
ON/OFF
RESET
PHONE1 - PHONE2
USB
LAN1 - LAN4
WAN
WPS
WIFI ON/OFF
Blinking A telephone connected to one of the phone ports has its receiver off
the hook, or there is an incoming call. There is no voice message in the
corresponding SIP account.
A SIP account is registered for the phone port, and there is a voice
On
message in the corresponding SIP account.
Blinking A telephone connected to the phone ports has its receiver off the
hook, or there is an incoming call. There is a voice message in the
corresponding SIP account.
Off
•
The Zyxel device is turned off.
• The VoIP function is not activated.
•
The SIP account is not enabled.
• The phone port does not have a SIP account registered.
Function
Connect the power cable here.
Press the ON/OFF button to switch on and off the device.
If you want to return the device to factory defaults because, for example, you forgot
your password or cannot access the Web Configurator, press and hold the RESET
button until the Power LED starts blinking. The password will be reset to the factory
default (see the device label) and the IP address will be 192.168.1.1.
Connect analogue phones to the phone ports to make phone calls.
Use the USB port for cellular WAN backup, file sharing, media server, and print server.
Connect computers or other Ethernet devices to the Ethernet ports for Internet
access.
Connect an Ethernet cable to the Ethernet WAN port for Internet access.
Press the WPS button for more than one second to quickly set up a secure wireless
connection between the device and a WPS-compatible client.
Press the WLAN button for more than one second to enable the wireless function.
6