21.3.1 Remote Management and NAT
When NAT is enabled:
• Use the MWR211's WAN IP address when configuring from the WAN.
• Use the MWR211's LAN IP address when configuring from the LAN.
21.3.2 System Timeout
There is a default system management idle timeout of five minutes (three hundred
seconds). The MWR211 automatically logs you out if the management session
remains idle for longer than this timeout period. The management session does not
time out when a statistics screen is polling. You can change the timeout period in the
System screen
21.4 WWW Screen
To change your MWR211's remote management settings, click Management >
Remote Management > WWW.
Figure 104 Management > Remote Management > WWW
The following table describes the labels in this screen
Table 68 Management > Remote Management > WWW
LABEL
Server Port
Server Access
Secured Client
IP Address
MWR211 User's Guide
DESCRIPTION
You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
Select the interface(s) through which a computer may access the
MWR211 using this service.
Select All to allow all computes to access the MWR211.
Otherwise, check Selected and specify the IP address of the computer
that can access the MWR211.
174