• Use the LAN screen to set the IP address for your MWR211 acting as an access
point.
6.3 What You Need to Know
See
Chapter 10
access point.
6.3.1 Setting your MWR211 to AP Mode
Log into the Web Configurator if you haven't already. See the Quick Start
1
Guide for instructions on how to do this.
To use your MWR211 as an access point, go to Maintenance > Sys OP
2
Mode > General and select Access Point mode.
Figure 31 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As
soon as you do, your MWR211 is already in Access Point mode.
When you select Access Point Mode, the following pop-up message
3
window appears.
MWR211 User's Guide
for a tutorial on setting up a network with the MWR211 as an
46