ZyXEL Communications MWR211 - V1.0 Manual page 210

If the problem continues, contact your ISP.
3
The Internet connection is slow or intermittent.
There might be a lot of traffic on the network. Look at the LEDs, and
1
check Section
information, try closing some programs that use the Internet,
especially peer-to-peer applications.
Check the signal strength. If the signal strength is low, try moving the
2
MWR211 closer to the AP if possible, and look around to see if there
are any devices that might be interfering with the wireless network (for
example, microwaves, other wireless networks, and so on).
Reboot the MWR211.
3
If the problem continues, contact the network administrator or vendor,
4
or try one of the advanced suggestions.
Advanced Suggestions
• Check the settings for bandwidth management. If it is disabled, you might
consider activating it. If it is enabled, you might consider changing the
allocations.
• Check the settings for QoS. If it is disabled, you might consider activating it. If
it is enabled, you might consider raising or lowering the priority for some
applications.
31.4 Resetting MWR211 to Factory
Defaults
If you reset the MWR211, you lose all of the changes you have made. The
MWR211 re-loads its default settings, and the password resets to 1234. You have
to make all of your changes again.
You will lose all of your changes when you push the RESET button.
To reset the MWR211,
Make sure the power LED is on.
1
Press the RESET button for longer than 1 second to restart/reboot the
2
MWR211.
Press the RESET button for longer than five seconds to set the
3
MWR211 back to its factory-default configurations.
MWR211 User's Guide
1.5. If the MWR211 is sending or receiving a lot of
210